- Note the charger ID, take a photo of the screen and lights, and check if it's one charger or the whole site.
- Make sure no one is charging, then turn the charger's breaker OFF for 30 seconds and back ON.
- If you can safely find the networking equipment that serves the chargers (router, access point or cellular gateway), unplug it for 30 seconds and plug it back in.
- Wait 10 to 15 minutes. It can take a few minutes for the charger to reconnect and for the status to update.
- Still offline? Call us from beside the equipment at 1-844-798-2438 or email support@swtchenergy.com with your photos.
What offline meansHow SWTCH respondsPower cycle step by stepOne charger or the whole site?Wi-Fi, cellular and EthernetKeeps going offlinePlanned work and changesWhen a technician is neededYour drivers in the meantimeBack onlineWhat to send us
The basicsWhat does offline mean?
An offline charger has lost its connection to the SWTCH network. It may still have power and its screen may still look normal, but the app can't start or track sessions on it, and we can't see or control it remotely.
A charger is marked offline after it misses a few check-ins in a row, so the status can take around 10 minutes to change after it drops, and again after it reconnects. The SWTCH system moves it to Troubleshooting automatically, and back to Active on its own when it reconnects. If it doesn't come back, our team opens a case and moves it to Under Repair while we work on it.
| You see | What it means |
|---|---|
| Offline | No connection to the SWTCH network. Usually power or internet at the site. |
| Faulted | Connected, but the charger reported an error. See Understanding Charger Error Codes and Safety Faults. |
| Troubleshooting | Set automatically when an active charger drops offline. Clears on its own when it reconnects. |
| Under Repair | Our team has an open case on this charger and it isn't available to drivers until it's fixed and tested. |
How can I see which chargers are offline?
In SWTCH Portal, go to Chargers. A red connection icon means the charger is offline. To see every charger that needs attention, filter Service Status by Troubleshooting and Under Repair.
What we doHow SWTCH responds
Our support team monitors your chargers 24 hours a day, 7 days a week. When a charger goes offline we follow the same three steps:
Keep your on-site contact up to date. The faster we can reach someone at the property, the faster your chargers come back. Send changes to support@swtchenergy.com.
Most common fixHow to power cycle a charger
A power cycle fixes most offline chargers. It's the same as restarting a computer, and it's safe when done this way:
Only switch breakers you're allowed to operate. Never open the charger, never touch damaged cables, and don't factory reset or change the charger's network settings. If a breaker trips again right after you reset it, leave it OFF and call us: that usually needs an electrician, not another reset.
Find the causeOne charger or the whole site?
What you see on site tells us a lot about the cause. Here's what we usually find in our cases:
| What you see | What it usually means |
|---|---|
| One charger offline, the rest are fine | Usually the charger's breaker or a weak signal at that spot. Power cycle that charger first. |
| Every charger at the site offline at once | Almost always the site's internet or power, not the chargers. Check the router, access point or cellular gateway and any recent power outage. |
| Screen is dark, no lights | No power. Check the breaker and whether there's a power outage or electrical work on site. |
| Screen on, but offline | The charger has power but no network. Restart the network equipment and check whether the building Wi-Fi changed. |
| Breaker keeps tripping | Don't keep resetting it. This points to an electrical issue (wiring, breaker size or a fault) and needs an electrician. See GFCI Breaker Tripping and Voltage. |
| Offline right after a network change | A new router, a new internet provider, or a new Wi-Fi name or password will disconnect the chargers. See Wi-Fi, cellular and Ethernet. |
| Many sites in your area at once | Could be a cellular carrier outage in your area. These usually clear on their own, and we'll keep you posted. |
ConnectivityWi-Fi, cellular and Ethernet
Your chargers reach the SWTCH network in one of these ways. Not sure which one your site uses? Ask us and we'll check.
Building Wi-Fi
- The chargers are set up with your Wi-Fi name and password. If either one changes, they disconnect. If you need to change them, please tell us first so we can plan the update, or keep the same name and password on the new equipment.
- Ask your IT team to confirm the network is up and that nothing changed (router replaced, new provider, new settings).
- Weak signal is a common cause of chargers that drop on and off. The fix is usually moving the access point closer to the chargers or adding one, with a clear line of sight.
Cellular gateway
- Many sites use a cellular gateway (a small modem near the chargers) managed by SWTCH. It needs power to work, so make sure it stays plugged in and isn't on a switch or timer.
- Don't move it, change its settings or swap its SIM card. If it seems damaged or missing, contact us.
- If a whole area loses cellular service, chargers come back once the carrier restores it.
Ethernet (wired)
- Check the cable is firmly connected at both ends and that the network switch or router it connects to has power.
Label the router, access point or gateway that serves your chargers (for example, "EV chargers, please don't unplug"). It helps your staff find it fast, and it stops it from being unplugged by mistake.
IntermittentMy charger keeps going offline
A quick disconnect now and then (about once a day) is normal. It's usually a short power or network blip and the charger reconnects on its own. If it keeps dropping over and over, let us know so we can find the root cause. The usual suspects are:
- Weak Wi-Fi or cellular signal at the charger's location.
- Network equipment that restarts, loses power or drops connections.
- Several chargers dropping at the same moment, which can mean the electrical circuit or the load setup can't handle them all charging together.
Tell us when it happens (times help), which chargers are affected and anything that changed on site recently.
Avoid surprisesPlanned work and changes on site
Give us a heads-up at support@swtchenergy.com before any of these, so we know the chargers will drop and can help bring them back:
- Planned power shutdowns, electrical work or construction near the chargers
- A new router, access point or internet provider
- A new Wi-Fi name or password
- Moving or replacing any equipment the chargers connect to
After the work is done, check the chargers. If any don't come back within 15 minutes, power cycle them and let us know.
Going onsiteWhen a technician is needed
If a power cycle doesn't work, someone needs to check the charger, the power and the network on site. Most of the time our team guides that person live on a troubleshooting call, so we can check the settings together while they're next to the equipment.
How to book the troubleshooting call
- Download the SWTCH Install app (Android or iPhone).
- Open the app and go to Support > Book a Troubleshooting Call, then pick a time.
- Book at least 1 to 2 business days ahead. Calls run on weekdays.
Here's a short video on how to book the call. The person onsite should have a laptop, an Ethernet cable, a screwdriver and access to the breakers and the network equipment.
Who covers the visit?
- Sites with SWTCH Care: onsite service is included. We arrange it and let you know when someone is coming. (Vandalism, Wear an Tear, and Installation defects might not be covered, or revised on a case by case basis, please ask us at support@swtchenergy.com)
- Other sites: your plan includes remote monitoring, remote support and access to the charging network, and onsite work is arranged by the property (for example, your installer or electrician). If you don't have anyone, we can find a technician near you and send you a quote first. Nothing is booked without your approval.
- Faulty hardware: if the technician confirms a part is faulty and it's under warranty, we replace it. See Hardware Warranty Claims, Replacements, and On-Site Service Guidelines.
Not sure if your site has SWTCH Care? Ask us at support@swtchenergy.com.
DriversYour drivers in the meantime
- RFID cards: some chargers can still start a session with a SWTCH RFID card while offline, if your site has that option turned on. It's worth a try.
- Other chargers: drivers can use another charger at your site that's online, or find one nearby in the SWTCH app.
- Session stuck as active: if the charger lost power or connection during a session, we can't end it until the charger is back online. Once it reconnects we can close it. Drivers can contact us about any charge they have questions about.
DoneOnce it's back online
- Start a short test session from the SWTCH app (not just an RFID card) and check it charges normally.
- Reply to our email or let us know it's working, plus anything you found or changed (for example, a tripped breaker or a new router). It helps us prevent it from happening again.
We'll confirm on our side, make sure nothing else is pending, and put the charger back in service for your drivers.
Faster supportWhat to send us
Sending these with your first message saves a lot of back and forth:
| Detail | Why it helps |
|---|---|
| Charger ID(s) and site address | The ID is on the front of the charger. |
| Photos | The front of each affected charger, showing the screen, lights or any error code. |
| Power | Is the screen on? Are there lights? Is the breaker ON? |
| How many | One charger, several, or the whole site. |
| What you tried | Power cycle of the charger and the network equipment, and the result. |
| Recent changes | Power outages, electrical work, construction, new router, internet provider, or Wi-Fi name or password. |
| Best on-site contact | Name and phone number of someone who can reach the breakers and the network equipment. |
For charger statuses and the rest of the Portal, see the SWTCH Portal FAQ.
Comments
0 comments
Please sign in to leave a comment.